Pinpoint aprs12/25/2023 ![]() I consider this to be a nice backup solution for tracking and reporting positions over APRS. You can view all the beacon data for this transmission here: Also, you will not see your own radio-received position on the PinPoint APRS map until you report at least two locations. I had to transmit once at one manually selected location and then again at another to simulate movement. Also I should note that without a GPS receiver tracking your position you’ll need to change your location slightly to get the digipeaters to not drop perceived duplicate packets. I imagine due to the fact that so many other people are transmitting on this frequency with more power than the Baofeng, that sometimes the beacon just doesn’t make it to the digipeater. NOTE: It took a few tries but it eventually worked. You can see the data being transmitted in the screenshot above from KM6ZPO-14. By the time I finished editing this article, I had 97 position reports from Santa Barbara to the Mexico border.Īfter setting my position within PinPoint APRS, I sent out a position beacon. Within a few minutes the position reports started coming in. I set the radio to 144.390 and made sure that the PinPoint APRS software was receiving data from the radio by opening the Comm Monitor Window. I did not collect information via APRS-IS. It would have been exactly line of sight except for a couple buildings directly in the path slightly higher than my view. The nearest digipeater able to pick up my beacon was 5.25 miles away. My operating environment was my 5th floor office in Newport Beach next to a window facing the digipeater.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |